3 trucks went up, 10+(happy) pilots. Fred with his "superwomen"/"wonder
women" tandem. Seriously, she came in a "wonder women" costume and
flew like that. I flew over, when they took off, and that was quite a scene-
her cape in the airflow...
We started to launch around 12:30, and the day gradually turned
on. Nice air, with some texture, lite winds. Climbs to near 4.5K. Flights of
1-2 hours, shiny faces in the LZ.
Oh, Kevin, thanks for the beautiful new tiedown rops up on the top, You
the menshch!!!
Tuesday
1 - 2 hours my eye! I didn't even get 25 minutes. 
Here's how it went down...
[youtube]http://www.youtube.com/watch?v=flUZLy0pxbQ[/youtube]
Here's how it went down...
[youtube]http://www.youtube.com/watch?v=flUZLy0pxbQ[/youtube]
Email me your tracklog and I'll verify.Vrezh wrote:Photoshop my eye!
You wanna bet? A case of Stella.
I'll keep it to show you next time.
Your A2 shows an unlikely number unless you flew 500' underground or there was a massive change in sea-level barometric pressure since you last zeroed it.
Your 5-Sec averages seem a bit high given the weather conditions.
It looks to me like your EEPROM may be going bad. I've had mine replaced on my 6030 along with other bits over time. Yours may be due for some checking by Steve Kroop.
I don't bet when it comes to flying but will be happy to analyze your tracklog in SeeYou.
Just kidding 
My 6030 started doing this a while ago. In flight it would work fine, but after
landing it would produce a wacked out "flight analysis".
As advised by Steve, I updated the software, keep the memory clean and
switched from 2 sec scan rate to 5 sec. That seemingly helped, but for a time
being. This was the first wacky output after a long string of normal
recordings. Gotta contact Flytec.
My 6030 started doing this a while ago. In flight it would work fine, but after
landing it would produce a wacked out "flight analysis".
As advised by Steve, I updated the software, keep the memory clean and
switched from 2 sec scan rate to 5 sec. That seemingly helped, but for a time
being. This was the first wacky output after a long string of normal
recordings. Gotta contact Flytec.
Good bluff, boychick! I ain't playing poker against you. ROTFLMAO!!!Vrezh wrote:Just kidding
My 6030 started doing this a while ago. In flight it would work fine, but after
landing it would produce a wacked out "flight analysis".
As advised by Steve, I updated the software, keep the memory clean and
switched from 2 sec scan rate to 5 sec. That seemingly helped, but for a time
being. This was the first wacky output after a long string of normal
recordings. Gotta contact Flytec.