Last night I finally did a deep dive on the audio settings of the DigiFly and attempted to make the sink alarm dramatically lower in frequency than the climb tone.
What I found out was that if you want a different base frequency for your sink alarm, you MUST choose MAN in the variometer profile setting. After choosing MAN, then the following parameters will be honored
- Style
Modulation
Pitch
Climb
Sink
The manual says the same thing but a little obscure
I have the settings to make the vario sound like the FAS profile for climb and will share those tonight when I get home.
I believe they are:
Style = 2
Modulation = 30
Pitch = 15 (I think, need to verify)
Climb = 550 (remember this is the base freq, it goes up from here)
Sink = 350 (the lowest it can go)
Using the simulator I was able to test these and it sounded correct.